Cap Opener
Mr.Hobbby Cap Opener Εργαλειο για ανοιγμα χρωματων Gunze -Tamiya
Mr.Hobby GT-56
Εργαλειο για ανοιγμα χρωματων Gunze -Tamiya Mr.Hobby GT-56
There are 28 products.
Mr.Hobbby Cap Opener Εργαλειο για ανοιγμα χρωματων Gunze -Tamiya
Mr.Hobby GT-56
Εργαλειο για ανοιγμα χρωματων Gunze -Tamiya Mr.Hobby GT-56
Liquid Decal Film Microscale
Restore old decals ,make custom decals ,ultra thin film
Mr.Hobby MC-131
A new type of "BRUSH ON" type cement, with improved drying speed and adhesive strength! It is suitable for attaching fragile pastic parts together quickly. You must put together the plastic parts, and then brush on this cement on the gap between the two parts.
Microscale Micro Liquitape A tacky adhesive for temporarily joining most modeling materials,easily removed,clean up with water
Micro Weld Microscale Liquid cement for Styrene plastic models ,Non toxic Formula Environmentally Safe
Microscale Micro Set
Micro Set prepares the surface with special wetting agents that cuts the oils in new paint and converts the adhesive on the back of the decal to a stronger and more lasting one. And finally, Micro Set slightly softens the decals film to make it more flexible so that it can conform better to the model's surface.
Microscale Micro-Mask liquid masking tape
Mr. Finishing Surfacer 1500 gray 40 ml
MR.HOBBY SF289
Mr.Hobby SF287
This is a surfacer with primer (base filling paint).
The material used in Surfacer 1000, which is gaining overwhelming popularity for plastic models has been improved for this product.
Surface attachment has been enhanced not only for plastic models but also for metal in etched parts and resin.
Spray type and bottle type are available. Color is gray.
MR.HOBBY Mr.Dissolved Putty
MR.HOBBY P119
Mr.Dissolved Putty is a highly effective liquid sealant putty with even better viscosity than Mr.Surfacer 500.This product makes sealing rough sections of plastic models incredibly easy.
Mr.FINISHING SURFACER 1500 WHITE
MR.HOBBY SF291
Mr.Surfacer 1000
MR.HOBBY B519
Mr.SURFACER 1000 contains finer granules than Mr.SURFACER 500. They are both used in much the same way but ,due to the finer granules after sanding with waterproof sand-paper , a perfectly corrected surface is possible. Available in bottle and spray.
MR.WHITE PUTTY R
Mr.White Putty R is a low viscosity version of Mr.White Putty. Because of the reduced viscosity, it is easier to apply to a small area compared with the existing product. After it has hardened, it provides a smooth cutting quality extremely close to the original plastic model material.
Mr.Hobby Paint Tray 10pcs
Μεταλλικά Δοχεία για Ανάμειξη Χρωμάτων Η συσκευασία περιέχει 10 τμχ
Mr.SURFACER 1200
Mr.Hobby SF286
Mr.SURFACER 1200 contains finer granules than Mr.SURFACER 1000. They are both used in much the same way.
Microscale Micro Sol for softening decals so they fit into or over panel lines.
Micro Sol setting solution is for the most difficult irregular surfaces you find on models. It completely softens the Microscale Decal allowing it to drape down onto the surface of the model conforming perfectly and without distortion.
Mr.Hobby Mr. Mark Softer NEO (40 ml) (Decal Softener)
Mr.Hobby MS-233