Home
-
-
There are 30 products.
Candy Golden Yellow Enamel
ALCLAD Candy Golden Yellow Enamel ALC-706
Alclad 706
Shake thoroughly before use. Do not thin. Apply over Aclclad Bright Silver Candy Base. Spray light coat at 20-25PSI. Wait 5 minutes. Apply further even coasts. Allow 5 minutes between each coat. Leave to cure for 2 hours before handling.
Klear Kote Semi-Matte ALC-312 Alclad
Alclad Klear Kote Semi-Matte
ALCLAD ALC-312
Liquid Decal Film
Liquid Decal Film Microscale
Restore old decals ,make custom decals ,ultra thin film
Micro Flat Varnish
Micro Flat Microscale Varnish Clear Finish for Models ,tough,non-yellowing high-quality finish ,easy water clean - up
Micro Liquitape
Microscale Micro Liquitape A tacky adhesive for temporarily joining most modeling materials,easily removed,clean up with water
Micro Weld Cement
Micro Weld Microscale Liquid cement for Styrene plastic models ,Non toxic Formula Environmentally Safe
Microscale Micro Set
Microscale Micro Set
Micro Set prepares the surface with special wetting agents that cuts the oils in new paint and converts the adhesive on the back of the decal to a stronger and more lasting one. And finally, Micro Set slightly softens the decals film to make it more flexible so that it can conform better to the model's surface.
Microscale Micro-Mask liquid masking tape
Microscale Micro-Mask liquid masking tape
PRISMATIC AQUARIUS Turquoise to Blue ALC-206 Alclad
ALCLAD PRISMATIC AQUARIUS Turquoise to Blue ALC-206
ALCLAD ALC206
Prismatic Maple" Copper red to Green ALC-202 ALCLAD
ALCLAD Prismatic Maple" Copper red to Green ALC-202
ALCLAD ALC202
Prismatic Scarabeus ALC-201 Alclad
Prismatic Scarabeus ALC-201 Alclad paint
Alclad 201
Prismatic Titanium to Blue/Green ALC-207 ALCLAD
ALCLAD Prismatic Titanium to Blue/Green ALC-207
ALCALD ALC207
Transparent Green ALC-404 Alclad
Alclad Transparent Green ALC-404 Alclad
Alclad 404
White Primer Micro Filler ALC-306 Alclad
Alclad White Primer Micro Filler ALC-306
Alclad 306
Pre-thinned for airbrush application, Dries in 10 minutes, No sealer required, and Does not lift when masked. To obtain a great finish: The surfaces to be painted must be thoroughly clean and free from dust and fingerprints, Airbrush at 12-15 psi, and Airbrush 2-3 inches away from the model.
Holomatic Spectral Chrome ALC-205 ALCLAD
ALCLAD Holomatic Spectral Chrome ALC-205
ALCLAD ALC205
Microscale Micro Sol
Microscale Micro Sol for softening decals so they fit into or over panel lines.
Micro Sol setting solution is for the most difficult irregular surfaces you find on models. It completely softens the Microscale Decal allowing it to drape down onto the surface of the model conforming perfectly and without distortion.
ΚΟΛΛΑ ΞΥΛΟΥ 200GR
WOOD GLUE
WOOD ADHESIVE FOR EXTERIOR USE STRONGER THAN THE WOOD ITSELF