3-blade boat propeller 40mm for M4
Graupner3-blade boat propeller 40mm for M4, Marine propeller 3 bladed Left rotating for M4 shaft
Graupner 2308.40L
There are 27 products.
Graupner3-blade boat propeller 40mm for M4, Marine propeller 3 bladed Left rotating for M4 shaft
Graupner 2308.40L
Graupner3-blade boat propeller 40mm for M4, Marine propeller 3 bladed right rotating for M4 shaft
Graupner 2308.40
Graupner 3-blade boat propeller M4 45mm Marine propeller 3 bladed right rotating for M4 shaft
Graupner 2308.45
Graupner 3-blade boat propeller M4 45mm Marine propeller 3 bladed Left rotating for M4 shaft
Graupner 2308.45L
Graupner 3-blade boat propeller M4 50mm Marine propeller 3 bladed right rotating for M4 shaft
Graupner 2308.50
Graupner 3-blade boat propeller M4 50mm Marine propeller 3 bladed Left rotating for M4 shaft
Graupner 2308.50L
GRAUPNER 3-Bladed Propeller 35mm M4 Left Rotating
GRAUPNER 2308.35L
Graupner Direct Drive Speed 400 6V
Power set for small RC sports models with 7 or 8 cells and a maximum all up weight of about 600g .Propeller size 13X13 cm Graupner 6064
Graupner Double Cruciform Bollard 25mm Double Cross Bollard 4pcs Bitts 25mm
Graupner Double Cruciform Bollard 35mm Double Cross Bollard 4pcs
Bitts 35mm
Liquid Decal Film Microscale
Restore old decals ,make custom decals ,ultra thin film
Micro Flat Microscale Varnish Clear Finish for Models ,tough,non-yellowing high-quality finish ,easy water clean - up
Microscale Micro Liquitape A tacky adhesive for temporarily joining most modeling materials,easily removed,clean up with water
Micro Weld Microscale Liquid cement for Styrene plastic models ,Non toxic Formula Environmentally Safe
Microscale Micro Set
Micro Set prepares the surface with special wetting agents that cuts the oils in new paint and converts the adhesive on the back of the decal to a stronger and more lasting one. And finally, Micro Set slightly softens the decals film to make it more flexible so that it can conform better to the model's surface.
Microscale Micro-Mask liquid masking tape
GRAUPNER Prop Shaft with stern tube and marine 3-blade propeller 30mm Diam. shaft 150mm long ,ccw running
Graupner 1228a
Graupner Speed 600 7.2V Electric Motor
Graupner 1793 Powerful standard electric motor with hightorque. Particularly suitable for direct driveoperation on 6 cells.Nominal voltage 7.2V, Operating voltage range3.6-8.4 VNo-load rpm 18200, Current drain at max.efficiency 12 AShaft diameter 3.17mm, Weight 220g
GRAUPNER TURBOMAT 6 PLUS MOBILE AUTOMATIC RAPID CHARGER
GRAUPNER 6428
Mobiule universal high perfomance automatic rapid charger for 4 to 7 NC cells .Variable charge current 3A,2A and 1A
For Connection to 230V mains or 12V car battery
Rapid Charge current variable up to 3a
Slow charge function
Safety timer for over charge protection
Five Led monitor system
Automatic charge reset function
Graupner 6418
RAPID CHARGE AND SLOW FUNCTIONS
STANDARD 60 -250 mA
Safety rapid charge timer
Protect against short circuit overlad an reverse polarity
Charges to 100% capacity
Delta Peak cut off detector
Automatic trickle charge function
Push button charge start/stop
Rapid charge suppreses if voltage too low
Graupner 3-blade boat propeller M4 30mm Marine propeller 3 bladed Left rotating for M4 shaft
Graupner 2308.30L
Graupner 3-blade boat propeller M4 60L Marine propeller 3 bladed Left rotating
Graupner 2308.60L
GRAUPNER Coupling Bush for 4mm Shaft
Graupner 3382
Microscale Micro Sol for softening decals so they fit into or over panel lines.
Micro Sol setting solution is for the most difficult irregular surfaces you find on models. It completely softens the Microscale Decal allowing it to drape down onto the surface of the model conforming perfectly and without distortion.